Article marked
Error occurred
Please try again later
OMEGA LIGHT SK
OMEGA LIGHT SK
is an extremely permeable roof underlay with full-surface water-tight acrylate adhesive.
- Waterproof UV acrylic adhesive
Available dimensions
| Article number | Type | Roll width | Roll length | Rolls / Pallet | Total area | Inquiry List |
|---|---|---|---|---|---|---|
| 3OMELISK | SK | 1.5 m | 50 m | 13 rolls | 975 m² |
|
Product data
Field of application
- For vented pitched roofs
- For vented closed facades
- Transport protection for construction elements of solid wood and wood-based material
- Weather protection
- Intermediate ceilings and walls
- Also suitable for use as permanent air-tight layer on CLT
Advantages
- full-surface
- rain-tight
- wind-tight
- UV-stabilized
- permeable
- easily cut
- anti-glare
- anti-slip
is an extremely permeable roof underlay with full-surface water-tight acrylate adhesive. The tear-resistant synthetic liner facilitates installation. Due to the wide sheets construction elements can be bonded over the full surface, as protection during transport and construction. The butt joints can easily be made lengthwise and crosswise with a 10cm overlap by following the markings.
- Outdoor exposure ceiling during construction
- 4 weeks
- Outdoor exposure wall
- 5 months
- Outdoor exposure pitched roofs from 14°
- 4 weeks
- sd-value
- 0.5 ±0,1 m
- Material composition
- 3-layer PP fleece with full-surface special adhesive
- Elongation (EN 12311-1) lengthwise
- 40 - 110 %
Processing guideline
Adhesive properties
OMEGA LIGHT SK adopts the functions of wind and air-tightness as well as weather protection, not however the function of a load-bearing connection. OMEGA LIGHT SK cannot be plastered or painted over.
Adhesive technique
OMEGA LIGHT SK must be bonded with the substrate over the entire surface. We recommend first cutting the required quantity to length, pulling the liner away a little and attaching the OMEGA LIGHT SK at one end of the construction component.The second step is to gradually pull off the liner on both sides, at the same time rubbing on the sheeting to keep it bubble-free, using e.g. a wide squeegee or wide, straight brush. The liner can be wound around a square timber and then pulled off. In this way the tension used when pulling can be evenly distributed and a crease-free and smooth bond is achieved. Overlaps of the adhesive tape should be min. 10 cm. Sufficient pressure must be applied to the open edge using a pressure roller.
Instructions
Adhesive properties
OMEGA LIGHT SK adopts the functions of wind and air-tightness as well as weather protection, not however the function of a load-bearing connection. OMEGA LIGHT SK cannot be plastered or painted over.
Adhesive technique
OMEGA LIGHT SK must be bonded with the substrate over the entire surface. We recommend first cutting the required quantity to length, pulling the liner away a little and attaching the OMEGA LIGHT SK at one end of the construction component.The second step is to gradually pull off the liner on both sides, at the same time rubbing on the sheeting to keep it bubble-free, using e.g. a wide squeegee or wide, straight brush. The liner can be wound around a square timber and then pulled off. In this way the tension used when pulling can be evenly distributed and a crease-free and smooth bond is achieved. Overlaps of the adhesive tape should be min. 10 cm. Sufficient pressure must be applied to the open edge using a pressure roller.
