OMEGA UVKB Facade Tape SK

The full-surface adhesive film is completely weather-resistant and permanently stabilised against UV.

Product data sheet

Available dimensions

Article number	Type	Roll width	Roll length	Rolls / Pallet	Total area		Add
3OMFASK	VFK	1.5 m	50 m	15 rolls	1125 m²

Request quote

Product data

Field of application

Protection of insulation and wood-based materials from the weather
For vertical components with shadow gaps of up to 50 mm

Advantages

rain-tight
wind-tight
UV-stabilized
permeable
easily cut
anti-glare
anti-slip

The full-surface adhesive film is completely weather-resistant and permanently stabilised against UV. The special coating allows it to be used behind semi-transparent and partially open facades, e.g. made of wood, expanded metal or glass. In order to protect the film against mechanical damage, care should be taken to ensure that the opening portion of the façade is limited to < 50% or has a maximum joint opening of 50 mm. Larger joint spacings require an object-specific approval from ISOCELL.

sd-value: 0.4 m

Material composition: PES nonwoven with single-sided TPU coating and full-surface acrylate adhesive

Tensile strength (EN 12311-1) lengthwise: 250 N/50 mm (±80)

Tensile strength (EN 12311-1) crosswise: 250 N/50 mm (±80)

Temperature resistance: -30–80 °C

Working temperature: -5–40 °C

Processing guideline

Adhesive properties

OMEGA UVKB SK adopts the functions of wind and air-tightness as well as weather protection, not however the function of a load-bearing connection. OMEGA UVKB SK cannot be plastered or painted over.

Adhesive technique

OMEGA UVKB SK must be bonded with the substrate over the entire surface. We recommend first cutting the required quantity to length, pulling the liner away a little and attaching the OMEGA UVKB SK at one end of the construction component.

The second step is to gradually pull off the liner on both sides, at the same time rubbing on the sheeting to keep it bubble-free, using e.g. a wide squeegee or wide, straight brush. The liner can be wound around a square timber and then pulled off. In this way the tension used when pulling can be evenly distributed and a crease-free and smooth bond is achieved. Overlaps of the adhesive tape should be min. 10 cm. Sufficient pressure must be applied to the open edge using a pressure roller.

Adhesion on the following substrates

Wood, wooden composite boards (OSB, MDF, 3S-boards, chipboard, plywood...), synthetics, metal free from oxidisation and rust, masonry, unsanded concrete.
The materials used must be free from dust, grease and silicone, the substrates must also be dry and stable. For rough wood, similar uneven substrates, and at low temperatures, we recommend pre-treatment of the substrate with one of ISOCELL’s primers.

Please note that at low temperatures, and even at slight temperature changes, surface condensation may occur. This has the effect of a release layer and reduces adhesion. After applying the construction waterproofing a curing process takes place. Depending on the temperature this can take 6 – 24 hours. Only then is complete adhesion achieved.

Tips

Walls: observe direction of water-flow. Always begin with adhesion at the bottom. Avoid open edges. Fold down at top.

Seal creases and connections to rough surfaces with OMEGA FROZEN adhesive paste.

Use in combination with UNI Primer Spray in the edge and overlap regions permits low working temperatures to -10° on a substrate free from ice and, when sufficient pressure is applied, increases reliability under extreme weather conditions.

Instructions

Adhesive properties

OMEGA UVKB SK adopts the functions of wind and air-tightness as well as weather protection, not however the function of a load-bearing connection. OMEGA UVKB SK cannot be plastered or painted over.